From the factory the Power Wagon models have roughly a 2" lift installed over the base models RAM 2500 and this system nets an additional 2" of lift (equivalent to 4" over standard RAM 2500) allowing clearance for 35" tires and improved offroad capability. More than just a "leveling kit" this system replaces the from coil springs and is designed to level out the stance while correcting suspension geometry.
Up front these systems use a pair of replacement 2" ProRide progressive-rate coil springs to achieve the extra height and offer controlled performance in the harshest of terrains. A high strength adjustable track bar with center pinch-bolt turnbuckle is supplied to re-center the front axle once lifted. Additionally a pair of extended length front sway bar links correct the OE sway bar operating angle for optimal performance while the replacement polyurethane bump stops properly limit up travel and brake line brackets to allow sufficient slack at full suspension droop. This kit is designed to take advantage of the Power Wagon's OE radius arms and is available with BDS's HD radius arm upgrade to add strength, clearance and caster correction. Buttoning up the front of this kit is your choice of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks offer improved ride and damper performance.
In the rear of the RAM 2500 kits a pair of 1.25" steel fabricated bolt-on coil spacers are used to level out the stance and maintain load capacity. These combined with the rear bump stop extension and your choice of NX2 or FOX 2.0 Performance Series IFP shock rounds out the rear of these2" lift systems. Get the look and the ride you are after with these new 2" lift systems from BDS Suspension.
Tire & Wheel Combinations
35x12.50 w/20x9 and 4.5-5" back spacing
35x12.50 w/18x9 and 4.5-5" back spacing
*Trimming may be required*
Est. Installation: 5 hours
Difficulty Level (easy 1 - 5 complicated): 3